A7 Rebuildable Atomizer - Chrome

$24.95
$8.00

Product Code:

Qty

Description

The A7 Rebuildable Atomizer
510 Threaded

Housed in a stainless steel tube and stainless steel internals with nylon insulators, this atomizer can be completely disassembled and put back together. The internals can be removed from the tube to ease the installation of the coil and wick. The center post is adjustable and can compensate for devices with slightly recessed connectors. This is only for the most experienced user as it requires a fair bit of technical aptitude and patience in re-winding the coil around the wick.

The A7 is designed for dripping and offers great flavor and vapor production. It utilizes a single coil masked with 3 individual wicks. This kit comes with a stainless steel Clarion drip tip. However, the A7 is compatible with most 510 drip tips. The A7 comes pre-installed with a 2.2 ohm coil (+/- 0.2 ohm). The air-hole is located at the battery connector like standard atomizers.

Dimensions:
With drip tip: 2.5" x 0.55" (length x diameter)
Without drip tip: 1.63" x 0.55" (length x diameter)

Due to the nature of this product there is no warranty. This product is for experienced users and requires technical knowledge in order to properly use it.

Rebuildable atomizer: The user of this atomizer must install wick and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Wick, wire and mesh sold separately.

Important Note:
Rebuildable atomizer (RBA) coils and wicks have known risks.

Rebuildables are for experts, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.

This is because:

1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used.
2. If it is not tested it is entirely the risk of the user.
3. Faulty wicks/coils WILL blow electronic devices.
4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection.
5. No new coil/wick assembly should be used on an electronic device until known to be safe.
6. These items destroy electronic devices if faulty. This is a known issue.